top of page
AX Molding Co., Ltd.
Specialized manufacturer of T-dies and feed blocks
We can handle a variety of applications, including high-precision thin film dies, sheet dies, and multi-layered products.
Tanzawa Techno Center (design, development, and manufacturing base)
0463-68-8223
FAX: 0463-57-8276
553-1 Soya, Hadano City, Kanagawa Prefecture, 257-0031
03-6424-7570
Head Office (Administrative and Accounting)
FAX 03-6424-4676
CINZA101, 2-8-2 Minami-Kamata, Ota-ku, Tokyo 144-0035
Reception hours: 8:30-17:30 (excluding weekends and holidays)

<Development and Prototyping (R&D, Medical, and Industry)>
1) Range of support (approximate)
・Material: PP, PE, TPU, Pebax, PFA, etc.
・Size: Outer diameter φ1mm or less to φ100mm ・Forming technology: Single lumen/multi-lumen tube (vacuum sizing method, internal pressure air method)
Multilayer tubes, braided tubes, coating molding equipment: tube molding equipment, braided tube molding equipment, electric wire equipment
Other incidental equipment (visual inspection equipment, regulator panel, etc.)
2) Development track record/case studies
#Development #Production Equipment | PE (Polyethylene) | In-line inspection and sorting of finished and defective products
・Challenge: Manual sorting of parts with dimensional variations or poor appearance is inefficient (automatic sorting)
・Response: In-line dimension (outer diameter, wall thickness, inner diameter) and appearance inspection is performed,
Design a function to sort products on the conveyor belt based on each error output.
・Effects: ・Prevention of defective products → Significant reduction in complaints and re-inspections
・Reduce start-up time/setup loss → Dimension inspection/judgment time reduced to almost zero
・Improved yield → At the same time, reduced scrap volume
・Reduce labor costs → Minimize inspectors

bottom of page

